Blue Clean 956920 조립, 관리 및 사용 지침 - 페이지 15

{카테고리_이름} Blue Clean 956920에 대한 조립, 관리 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Blue Clean 956920 17 페이지. 1800 psi electric pressure washer

페이지 인쇄

care and maintenance

TROUBLESHOOTING

PROBLEM

CORRECTIVE ACTION

The unit is running

1. Check the water source. Unclog the nozzle on the lance. (See nozzle cleaning

but there is no

water flow.

Why is water leaking

1. Make sure there is an o-ring at the end of the metal tip of the high pressure

where the high

pressure hose

connects to the

spray gun?

I can't remove the

1. All lances and the detergent tank are attached and removed from the spray

lance from the spray

gun. What should I

do?

2. Or, hold the spray gun and lance in an upright position with the nozzle end on

TroubleshooTing

The power washer

1. It sounds like your power washer is working just fine. When the water is

turns on for

2 seconds, shuts

off, and will not turn

back on. Do I have a

defective unit?

2. Turn the power switch to off, hold in the trigger on the spray gun, so that you

https://www.kipogeorgiki.gr/

instructions under "Cleaning nozzles".) Or take off the lance and just spray out

of the spray gun. This will indicate if the problem is with the lance.

hose. If no o-ring is present, the connection between the hose and spray gun

will leak. O-Ring Kits are available online at

www.arblueclean.com or call Customer Service at 1-866-235-5112 to

place an order.

gun in the same manner. Insert the quick-release end of the lance/detergent

tank into the spray gun. Press the spray gun and lance together (about a 1/8")

and turn clockwise. The lance will lock in place. Remove the lance by reversing

this procedure. Press the spray gun and lance together and turn counter

clockwise. The lance will slide out.

the floor. Push the whole assembly straight down to loosen the connection,

and then follow the removal process again. You may also spray soapy water or

a lubricant in the area where the lance connects to the spray gun.

connected, the accessories are assembled properly, and the power switch is

turned on, the power washer may turn on for 1 - 2 seconds to prime the pump. It

automatically shuts off and waits for the spray gun trigger to be pressed. When

the trigger is pressed, water starts flowing through the pump. The water sensor

in the pump "senses" the moving water and automatically turns the power

washer on.

have a steady stream of water. While you are holding the trigger open on the

spray gun, at the same time, turn the power switch on.

https://www.kipogeorgiki.gr/