Blue Clean AR 112 S 조립, 관리 및 사용 지침 - 페이지 7

{카테고리_이름} Blue Clean AR 112 S에 대한 조립, 관리 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Blue Clean AR 112 S 17 페이지. 1500 psi electric pressure washer

ASSEMBLY INSTRUCTIONS

OFF/O

1500 PSI

Slide cord hook holster (D) onto right side, when facing

unit, of power washer unit (C) as shown.

Note: This step does not require any screws.

Connect the other end of high pressure hose (E) to

spray gun (F) by inserting the silver metal tip of high

pressure hose into the fitting just ahead of trigger

guard. It will lock into spray gun with a "click". Confirm

hose is locked into spray gun by slightly pulling on

hose. The hose is now securely attached to spray gun.

Note: DO NOT press button on underside of gun when

connecting hose to gun.

ON/I

High Pressure Hose Assembly

Screw high pressure hose (E) clockwise onto bottom

front of power washer unit (C). Pull back collar and insert

o-ring post into water outlet far enough so collar can

thread onto outlet threads until hand tight. If it takes

fewer than six turns you have not properly tightened the

high pressure hose fitting. It is easier to position the

power washer in front of you to ensure that the threads

are started correctly. Failure to properly tighten high

pressure hose will result in the hose slipping or popping

off immediately upon turning unit on. Do not worry about

damage if this occurs–just reinstall and take extra care

when screwing on the high pressure hose fitting.

Note: DO NOT use pliers or locking pliers to tighten.

To release hose (E) from spray gun (F), press button on

underside of gun toward trigger guard. The hose will

slide out from connection.