Blue Clean AR 2N1-Q 조립, 관리 및 사용 지침 - 페이지 13

{카테고리_이름} Blue Clean AR 2N1-Q에 대한 조립, 관리 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Blue Clean AR 2N1-Q 20 페이지. Electric pressure washer 2050 psi

OPERATING INSTRUCTIONS

Removing Power Washer Unit from Frame for

Handheld Operation

• Locate latches on the lower side of frame. Unlock

latches by pulling downward on the latches. Place a

foot on the pad at the front of the lower frame and

then lift the power washer unit off the frame.

Operation Tips

• If you hear the motor run intermittently when the

trigger is not being squeezed, that is normal.

The pump is priming itself so it is ready to operate

when the trigger is squeezed. Turn off the power

washer if not being used after five minutes.

• Keep the nozzle cleaning wire for use in unclogging

the nozzle. If you lose the cleaning wire, a

straightened paper clip also works.

How to Avoid Damaging Surfaces

• Damage to surfaces being cleaned occurs because

the impact force of the water pressure exceeds

the durability of the surface. Bare wood can be

penetrated, paint can be peeled off, etc. You can vary

the force of your power washer by controlling:

1. The angle of the surface being cleaned.

2. The distance of the nozzle from the surface being

cleaned.

• Never use a narrow high pressure stream of water on

soft surfaces susceptible to damage.

• Use the 25˚ angle quick connect nozzle when

cleaning windows. Be sure to place the nozzle

approximately 4 to 5 ft. away from the window with

the nozzle at 45° angle. Squeeze the trigger and vary

the spray pattern and angle until optimum cleaning

efficiency is achieved.

Using Power Cord

• Remove the power cord from the unit by swiveling the

cord hook to the right or left. The power cord then can

be slid off to either side of the power washer unit.

• Swivel cord hook back to center when ready to wrap

the cord back into place for storage.