DOBE DB400 사용자 설명서 - 페이지 5

{카테고리_이름} DOBE DB400에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DOBE DB400 9 페이지. Dog training bark collar

PAIRING THE COLLAR WITH REMOTE

Channel 1 and/or 2 are used when you want to MANUALLY trigger a

response when your dog barks or does a bad behavior that you want

to correct.

NOTE: We has been paired the collar with remote. So you can easy

right out of the box. Usually, one collar was paired to the Channel 1,

another one paired to the Channel 2.

HOW TO PAIRING THE COLLAR WITH REMOTE

1. Make sure the toggle switch on Channel 1 Position.

2. Hold the button on the collar down for 3 seconds. You will hear 1st

beep from the collar and the LED light will flash green to confirm it

is in pairing status.

3. Within 10 seconds, press and hold

button on the remote to pair the collar with

the remote. you will hear 2nd beep from the

collar, this confirms the pairing is complete.

Hold the button for 3 seconds

Press and hold one of mode buttons

4. Press the

button to verify that the

Remote Training Mode is working.

NOTE: Put the test light over the Contact Points of the collar and then

press the SHOCK button to verify SHOCK mode is working.

Use the Intensity Dial on the remote to set the intensity level from

1-100 for Channel 1 or 2. Currently Intensity is 40 in use. the BEEP

mode is non-adjustable level.

If you want to pair another collar to the same remote, change the

toggle switch to Channel 2 and follow the same instructions.

HOW TO USE THE ANTI BARK MODE

Channel A is used when you want the collar to AUTOMATICALLY

trigger a response when your dog barks.

Change the toggle switch on the remote to Channel A position. It is

Anti Bark Mode now and will default to one of Anti Bark Mode, but you

can change the modes any time.

Run to the

Anti Bark Mode

Back to the Remote

Training Mode

NOTE: We was paired the collar to Channel 1 before, we have back

to the Channel 1. it is back to MANUALLY remote training mode.