Doberman Security SE-0119 빠른 시작 매뉴얼
{카테고리_이름} Doberman Security SE-0119에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Doberman Security SE-0119 2 페이지. Wireless door alarm w/remote, magnetically triggered door alarm and remote control
페이지 인쇄
PACKAGE INCLUDES:
Main Unit ... 1PC
Magnetic Sensor ... 1PC
Remote Control ... 1PC
INSTALLATION:
Simply peel and stick the alarm to the door or any other place you wish to protect.
For best performance, keep the distance between the Main Unit and Magnetic Sensor no larger than half an inch.
The Magnetic Sensor can be installed on either side of the Main Unit. (see drawing below)
BATTERY INSTALLATION/ REPLACEMENT:
Main Unit :
Set the swtich to OFF and slide down the battery cover.
Follow the polarity instructions to insert 3 AAA Alkaline batteries (not included).
The red LED light will flash once if the batteries are installed correctly.
Put the battery cover back on.
Remote Control :
Unscrew the back cover to insert or replace replace 1 fresh CR2032 battery. Follow the polarity instructions.
Press any button on the remote Control. The red LED will light if the battery is installed correctly.
OPERATION:
Remote Mode :
Make sure the Magnetic Sensors are aligned and batteries are installed correctly.
After installing the batteries, slide the switch to
Slide down the battery cover and press the small button beside the battery compartment once. A beep will sound, and the
red LED will flash for 5 seconds. The Main Unit is now waiting for the Remote Control to learn the code.
Press any button on the Remote Control and you'll hear a Bi-Bi sound. This indicates the code has been learned successfully.
Press the ON button on the Remote Control, a Beep will sound, and the Main Unit will be armed in three seconds. The red
LED will flash three times.
Press the OFF button on the Remote Control, a Bi-Bi will sound, accompanied by a flashing red LED. The device is now
disarmed.
Under ARM status, once the door is opened, the alarm will go off continuously for 30 seconds.
Turn off the alarm by pressing the OFF button on the Remote Control or slide the switch to OFF on the Main Unit.
Manual Mode :
Make sure the Magnetic Sensors are aligned and that the batteries are installed correctly.
Slide the switch to
Once the door is opened, the alarm will go off continuously for 30 seconds.
Turn off the alarm by sliding the switch to OFF.
NOTES:
The Magnetic Sensor can be installed on either side of the Main Unit, to allow for doors that open from the left or the right.
Please replace with new batteries if the red LED on the Main Unit flashes at 10 second intervals, or the Remote Control range
becomes obviously shorter.
WARNING:
The high pitched alarm sound may injure hearing if in close proximity to the ears. This alarm contains small parts and is not suitable
for children.
DISCLAIMER:
All Doberman Security items are strenuously tested by our experienced R&D teams. Doberman, however, does not guarantee that
this item will prevent all theft and/or attacks from occurring. This item is only meant to act as an alarm in emergency situations.
LIMITED WARRANTY COVERAGE:
If your product does not work properly because of a defect in materials or workmanship, Doberman will, for the length of the period
as follows, which starts with the date of original purchase ("warranty period"), replace it with a new or a refurbished product.
SE-0119 WIRELESS DOOR ALARM W/REMOTE
Magnetically Triggered Door Alarm And Remote Control
, and the Main Unit will be armed in three seconds and the red LED will flash three times.
, and the red LED will flash once.