Dobinsons Isuzu D-Max 2012 on 설치 매뉴얼 - 페이지 13

{카테고리_이름} Dobinsons Isuzu D-Max 2012 on에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dobinsons Isuzu D-Max 2012 on 13 페이지.

Method

1. The stainless loops may be removed from the bullbar if this makes it easier to work on, however if using a

cordless drill this is not a necessity. If removing the loops, do not over tighten the loop retaining bolts when

re fitting.

2. Ensure the loops are first completely clean and dry.

3. Fit the polishing buff wheel to the drill or buffing tool –take note of the maximum wheel speed and rotation

direction.

4. It is recommended to follow specific instructions on the packaging of the buffing wheel for best results.

However if no instructions are provided the following guidelines can be used:

A). Carefully dress the buff wheel with the compound across the rotating wheel for a few seconds, taking

care not o apply too much compound, it is better to apply a little compound more frequently than to

overdress the buff.

B). Gently buff the work area with the buffing wheel and with light pressure move back and forth across the

job.

C). After polishing use a soft, clean, dry rag to clean the surface and inspect in the light for an even finish.

D). Once complete clean thoroughly again with a sponge and warm water.

Dobinsons Spring and Suspension