ET Solar ET-P672250 설치 및 조립 지침 - 페이지 7

{카테고리_이름} ET Solar ET-P672250에 대한 설치 및 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ET Solar ET-P672250 12 페이지. Solar modules

to ensure undisrupted electrical energy output from the array. The hex nut in the exit

position on the junction box is used to hold a rubber ring to seal the box.

When disconnecting the connectors of a photovoltaic module in a module array that is

exposed to sunlight, electric arcs may result. Such arcs may cause burns and fires.

Therefore, PV system commissioning and maintenance must be performed by a qualified

electrician in accordance with the NEC. Before disconnecting a module in a solar array,

disconnect the string of module from the DC Disconnect at the inverter side, and then

fully cover the module with an opaque material.

negative connectors of a module exposed to sunlight.

Wiring must only be completed by a qualified engineer with

suitable tools.

The specification of wire for the electric coupler that ET Solar provided is 1 x 4.0mm

Equivalent wire should be used if the user prefers to use his own wire. When the

module's rated current is lower, 12AWG wire is recommended for use, and the strength

of the wire should be taken into consideration. ET Solar does not provide any output

wiring for module installation.

ET Solar modules are designed to use copper wire only. The working temperature of wire

and J-box is –40℃- 90℃. The wiring box interior is not intended for field access, and no

serviceable parts are inside.

The installation in Canada shall be in accordance with CSA C22.1, Safety standard for

electrical installations, Canadian Electrical Code, Part 1.

3.3 Output Voltage, Current and Maximum Power

The open-circuit voltage (Voc), short-circuit current (Isc) and maximal power (Pmax) are

printed on the PET label on the backside of the module. The electrical characteristics are

within ±10 percent of the indicated values of Isc, Voc and Pmax under standard test

Do not short the positive and the

WARNING!