AKONA HAVANA 소유자 매뉴얼 - 페이지 5

{카테고리_이름} AKONA HAVANA에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AKONA HAVANA 12 페이지.

A S S E M B L Y I N S T R U C T I O N S

UNPACK THE CONTENTS

Unroll the board a on a flat surface. Make sure there are no sharp objects under the

product that might puncture the product.

INFLATE THE BOARD

Fasten air hose to pump. Locate the air valve on tail section of the board deck. Open

valve cover. Make sure the inner valve is disengaged in the "UP" position. Connect air

hose to air valve.

Begin pumping. Inflate board to 14-15 PSI.

Disconnect air hose from valve. Inner valve will prevent air from escaping when

disengaged in the "UP" position.

Havana boards can hold up to 15 PSI; however, the recommended PSI is 15 PSI as the

board will remain rigid at 15 PSI and no further benefit is gained when inflating over

If inflated to 15 PSI and then placed in direct sunlight, pressure will increase and the

board will expand from the heat causing potential over inflation and damage to the

C A U T I O N !

DO NOT OVER INFLATE

15 PSI.

seams. This is NOT covered by warranty.

O W N E R ' S M A N U A L