DOCK LIFEGUARD DOCK LIFEGUARD 사용자 설명서 - 페이지 8

{카테고리_이름} DOCK LIFEGUARD DOCK LIFEGUARD에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DOCK LIFEGUARD DOCK LIFEGUARD 15 페이지. Dock warning system

Out of the Water

•

Don't panic;

•

Proceed to Shore

•

Kill Power to the dock via the circuit break on the shore

•

Call 911 and your local electrician

WARNING!

Alarms have various limitations. See "Limitations of Stray Electricity Detectors" for details.

Calling a Qualified Electrician to Find and Repair the Problem

If the Dock Lifeguard units detects stray electricity in the water. Contact a local electrician that is

familiar with local electrical codes on boat docks to diagnose and solve the problem.

If You Suspect a Problem

Dock Lifeguard may not operate properly because of faulty power supply or installation in an improper

location. Clean the Dock Lifeguard as described in "Regular Maintenance", then test the detector again.

If it fails to test properly when you use the test button, or if the problem persists, replace the Dock

Lifeguard unit immediately.

•

If you experience frequent non-emergency alarms:

o Check and Measure for electricity in the water

o Very proper for proper safety ground bonding of your dock.

Technical Information

Lethal Voltage is 2 volts AC per foot. The Dock Lifeguard units are setup to trigger at approximately

1500 millivolts. To see exact settings of your system, you need to reference the sensitivity jumper

settings on the mother board and trigger level of the alarm, as these items are configurable.

The following link a reference to the USCG In-Water Shock Hazard Mitigation Strategies.

http://www.boatus.com/seaworthy/assets/pdf/in-water-shock-hazard-mitigation-strategies.pdf

Product Specifications

Sensitivity meter is in 125 millivolt levels. Sensitivity can be increased by setting jumpers on the

mother board. Refer to YouTube video on the DockLifeguard.com website on how to set the jumpers.

How the Unit Determines When to Alarm

The default factory setting of the Dock Lifeguard will trigger when stray electricity is detected in the

water above the unit threshold of approximately 1500 millivolts. This trigger sensitivity will increase

with increased levels sensitivity via the sensitivity jumpers and trigger point adjustments made on the

motherboard.

• Alarm Trigger Level: The trigger level of the alarm can be adjusted to help

filter out higher levels of ambient voltage in the water or to alarm at a