Dock N Stow GEN1 작동 및 지침

{카테고리_이름} Dock N Stow GEN1에 대한 작동 및 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Dock N Stow GEN1 2 페이지.

Read All Instructions! Failure to Follow All Instructions Listed Below May Result in An Unsafe or Dangerous

Condition.

Contents of package: 1 Dock N Stow; 4 grey spacers; 1 adjustable flat bungee; 1 adhesive backed silicone rubber strip.

Dock N Stow Assembly:

Step 1

- Determine trailer frame location you will be using for your new frame mounted Dock N Stow stabilizer block. This location will need 7 inches of space.

Step 2

- Measure the top width of the trailer frame; This measurement is used to determine how many spacers are needed for your frame size.

•

3-inch trailer frame requires no spacers.

2.5 inch trailer frame requires two spacers. One spacer will be used on either side of the channel at the bottom of the block.

•

Slide spacers into dovetail grooves until they snap into the bottom of the block.

2 inch trailer frame requires four spacers. Two spacers will be used on either side of the channel at the bottom of the block.

•

Slide spacers into dovetail grooves until they snap into the bottom of the block.

Step 3

- Attach silicone non-slip tape

Remove back of silicone rubber tape and apply to the center channel on bottom of block (prevents slipping on frame). Tape should

•

be applied after your spacers (if required) are in place to ensure the tape is centered and wouldn't interfere with spacers ability to

snap in place.

Step 4

- Remove top insert if necessary for use with caster wheel

•

If a wheel is on bottom of your jack post, remove top insert for wheel dock using Phillips head screwdriver.

Thank you for purchasing a Dock N Stow product!

GEN1 Operation and Instruction