DockCraft CR 100 매뉴얼 - 페이지 11

{카테고리_이름} DockCraft CR 100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DockCraft CR 100 15 페이지.

Now that the webbing length is set, Secure Loose end of webbing length

Position the 1st Webbing Keeper approximately

12 to 15 inches down from the cradle handle; on each

web strap.

Thread the loose end of webbing through Webbing Keeper

(each side of unit)

Cam Buckle Loose End of Webbing

Cam Buckle Kayak End of Webbing

Note:

It is much easier to thread the webbing through the webbing keeper with the

Kayak out of the Kayak Rack.

Reposition the 2

webbing keeper and thread, similar to above, such that there

is 1 to 3 inches of webbing extended beyond the webbing keeper after threading.

Reload your Kayak , and rotate your kayak into its storage position.

You may place your Paddle in the loop between the handle and the 1

To UNLOAD: Note, if your paddle is stored in your Canoe Rack, remove your paddle first and set aside.

Canoe Operating Models

1 - Before unloading, check to Ensure that there are no objects or people in the path of the canoe when rotated

toward the water.

2 - Standing on the Dock, grasp the pulley rope in one hand and then grasp the center of the handle.

3 - Rotate the Latch Plates on both Pivot Laterals 90 degrees counterclockwise. Note: Securely

hold the handle as the Latch Plates are rotated out of the way, the weight of the Canoe will cause the Canoe

Rack to want to rotate toward the water.

4 - Firmly holding the pulley rope, slowly lower the canoe into the water, by releasing (hand over hand) the

length of the tether cord until your canoe is in the water.

5 - Secure the end of the pulley rope that is left in your hand around the cross bar such that you may float your

canoe out of the rack.

6 - Float your canoe completely out of the rack and then pull on the pulley rope, to lift the cradle back into the

storage position.

7 - Rotate the Latch Plates back into its holding position such that the cradle will not rotate back into the

water when released.

8 – Enter your Canoe ensuring you are clear of the rack, grab your paddle and start your voyage.

as follows:

The Setup is now Complete.

Operating Instructions

Page 11 of 15

webbing keeper