DockCraft CR 100 매뉴얼 - 페이지 7

{카테고리_이름} DockCraft CR 100에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DockCraft CR 100 15 페이지.

페이지 인쇄

Installation Procedure for Your - Series 100 Docksider

Series 100 – Bolt On Dock Mount Installation

1 - Select a position on your dock where you choose to mount your Kayak Storage Rack.

Ensure there are not any electrical or structural components in the area.

2 - The Docksider should be mounted on 1 section of your dock.

3 - Make sure the wood on your dock is solid (not cracked or rotting) at the installation

position.

4 - Ensure there are no obstructions above or below your dock.

5 - Place one Dock Mount on your Dock and position as shown below

6 - Install

Dock Surface Mount

Your Dock

At the install position align Dock Mount as shown above

With a pencil scribe the hole locations (2) on dock surface

While the dock mount is positioned as shown above

Install the TOGGLER® brand SNAPTOGGLE® anchor *

Hold metal channel

flat alongside plastic

straps and slide

channel through hole.

Minimum clearance

behind wall: 1-7/8"

* "U.S. Patent no. 6,161,999 and foreign counterparts thereof. Other patents pending. TOGGLER & typeface

and SNAPTOGGLE are worldwide registered trademarks of Mechanical Plastics Corp."

Dock Mount is

positioned against the

side of your dock

Hold ends of straps

between thumb and

forefinger and pull

toward you until

channel rests flush

behind decking. Slide

plastic cap along straps

with other hand until

flange of cap is flush

with decking

- Use a ½ in. diameter drill for hardware provided

- Use a 1/8 in. diameter drill for pilot for ¼ lag bolts

- Use a ¼ in. diameter drill for ¼ machine screws and nuts

Note:

If you have a wooden structure under

your decking at the 2 ¼ inch location,

you may want to consider using a lag

bolt.

Drill ½ diameter holes through Dock Decking Surface

Ensure there are not any electrical or structural

components near the hole you are drilling. Also

check 26 to 32 inches away where you will mount the

second Dock Surface Mount

Secure Surface Mount to Dock

washers and ¼ - 20 screws provided (2)

Snap straps at wall

by pushing side to

side, snapping off

straps level with

flange of cap.

Note:

Secure Dock Surface Mount with

Use 7/16 wrench or socket.

Page 7 of 15