Fleet Complete AT1000 자체 설치 매뉴얼 - 페이지 4
{카테고리_이름} Fleet Complete AT1000에 대한 자체 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Fleet Complete AT1000 4 페이지. Asset tracker
페이지 인쇄FAQ
How do you install the AT1000?
The AT1000 can be installed by referring to
the installation guide provided. The mount-
ing cradle is secured to the asset using 4 sup-
plied screws, the AT1000 device is snapped
into the cradle mount, and finally the device
is secured to the cradle using 4 zip ties.
Does the AT1000 have a mag-mount option?
Yes, the AT1000 also has a magnetic mount
available as an accessory. The 4 cradle mount-
ing screws are replaced with 4 magnets to cre-
ate the magnetic mount cradle.
How do you turn on the AT1000 device?
Place the unit in the mounting cradle (make
sure it's fully inserted and the tamper switch
is pressed), then press and hold the emer-
gency button on the front. The power LED
should light, and glow for ~3 seconds. After
the power LED stops glowing, and the net-
work/cell LED blinks, stop holding the emer-
gency button down. Verify that the network/
cell LED blinked twice. The two blinks indi-
cate that the AT1000 successfully connected
to the cellular data network. When a success-
ful data call is made, the device will transmit
a location snapshot to FC.
How many inputs does the AT1000 have?
The AT1000 has 3 available inputs: 2 general
purpose inputs, and a Power ON/OFF input
that tracks the status of external power.
What voltage range is the AT1000 setup to
work with?
The AT1000 can use any voltage between
9- 32V DC for the power supply.
What is expected battery life?
The internal battery (3.7V 13.6Ah), can last
up to 3 years without recharging, based
on 1 position transmission/heartbeat ev-
ery 24 hrs.
How long does it take for the battery to
recharge?
Once the battery is fully discharged, it
takes 24 hrs for a full charge.
Does the temperature affect the charging
of the AT1000 battery?
For the standard AT1000, the built-in bat-
tery charger is normally activated when
external power is turned ON, and the en-
vironmental temperature is between 0 – 45
Celsius, or between 32 – 113 Fahrenheit. If
the temperature falls outside of that range,
the battery will not charge.
How long does it take for the AT1000 de-
vice to report the start and end of a trip/
movement?
If configured to report on motion, the
AT1000 typically reports the start of a trip
after 2 minutes of constant motion. Simi-
larly, the end of a trip is reported once the
device is sitting still for more than 2 min-
utes (no movement).
What's the right data plan for my expect-
ed use of an AT1000?
Please use the AT1000 Data Usage Calcula-
tor to calculate your expected data use.
Can the AT1000 device be configured to
detect trailer tethering?
Yes, either one of the 2 general purpose in-
puts can be used to detect the connection/
disconnection of the trailer tether, or the
main external power input can be used to
detect tethering status based on power sta-
tus (power is ON = trailer is tethered).
fleetcomplete.com
1 800 220 0779 |