ETA Systems PD9LV 소유자 매뉴얼 및 작동 지침
{카테고리_이름} ETA Systems PD9LV에 대한 소유자 매뉴얼 및 작동 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. ETA Systems PD9LV 2 페이지.
페이지 인쇄October 1998
OWNER'S MANUAL
OPERATION INSTRUCTIONS
ETA's line of Conditioned Power
Distribution units are designed to
prevent electrical damage to sensitive
electronic equipment from high
amplitude/short duration spikes,
random surges, and EMI/RFI noise,
which is inherent in utility power lines.
Power line sources which are not
preconditioned or filtered can affect
reliable operation of sensitive audio,
computer, and other electronic
equipment, and may cause premature
failure, expensive repairs, or unan-
ticipated replacement from non-
repairable damage.
As inherent problems in utility AC
power lines increase for various
reasons, and the need for noise-free,
conditioned power increases, ETA is
there with the units to protect your
valuable electronic equipment. With
present demands on the power utilities,
voltage spikes, power surges, electri-
cal noise, and power failures are
commonplace. This "garbage" in the
power delivered can reduce the fidelity
of audio systems, cause premature
®
SYSTEMS
A Creative Light & Sound Company
Division of National Biological Corporation
1532 Enterprise Parkway • Twinsburg, Ohio 44087
330-425-3388 • 800-321-6699 • Fax: 330-425-9700
http://www.etasys.com E-mail [email protected]
failure, or result in extensive damage
or destruction of electronic equipment.
ETA Conditioned Power Distribu-
tion units feature a master power switch,
conveniently located on the front control
panel, that switches the rear panel AC
outlets ON and OFF. An LED next to
the master power switch indicates the
power conditioning circuitry is working
and the rear panel AC outlets are
powered. Maximum total wattage input
is 1800 watts and the 8 power output
receptacles, located on back panel
and one on front panel, are protected
with a 15-amp (total unit) resettable
circuit breaker.
Note: The front panel LED is
normally lit when the power switch is in
the ON position. If the power switch is
ON and the LED is not lit, power may
still be present on the output AC
receptacles, but the power conditioning
circuitry is not working. Do not continue
use of the power conditioning unit and
refer trouble-shooting to a qualified
electronic technician or contact ETA
Customer Service for assistance.
All designs and specifications are subject to change without notice. Copyright © 1997 ETA Systems.
9 L
PD
9 LV
PD
9 L/PD 9 LV
BACK PANEL PD
EASY INSTALLATION
The PD9L and PD9LV is easily mounted
into a standard 19-inch rack or placed
into a free-standing position. With the
PD master power switch in the OFF
position, plug the line cord into a
convenient AC receptacle. Place the
unit's power switch into the ON
position and check that the front panel
LED is l i t . The lit LED indicates
conditioned and filtered AC power is
connected. Then, with their master power
switches in the OFF position, plug the
equipment to be protected into the PD's
rear panel AC receptacles. Turn on the
power switches of the equipment plugged
into the PD9L or PD9LV.
NOTE: The PD9L and PD9LV are
UL recognized and have a one-year
limited warranty.
TM