FLEMA FPL-1.5TF 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} FLEMA FPL-1.5TF에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. FLEMA FPL-1.5TF 6 페이지. 1-1/2 ton truck transmission jack

페이지 인쇄

and well lubricated to prevent foreign matter from entering the system. If the jack has been

exposed to rain, snow, sand, or grit, it must be cleaned before it is used.

Store the jack in a well-protected area where it will not be exposed to corrosive vapors,

abrasive dust, or any other harmful elements.

Regularly lubricate the moving parts.

To check the oil level, place the jack on level ground and lower the lift arm completely.

Remove the ﬁller plug. The oil level should be within 3/8' of the ﬁller plug hole. Do not

overﬁll. If necessary, add approved anti-wear hydraulic jack oil, and install the ﬁller plug

again.

IMPORTANT: The use of alcohol, hydraulic brake ﬂuid or detergent motor oil could

damage the seals and result in jack failure.

Inspect the jack before each use. Do not use jack if damaged, altered, modiﬁed, leaking

hydraulic ﬂuid or with missing or loose components.

7. TROUBLESHOOTING

Repair procedures must be performed in a dirt-free environment by qualiﬁed personnel who

are familiar with this equipment

Trouble

Cause

Jack does not lift

1. Release valve is open.

2. Low/no oil in reservoir.

3. Air-locked system.

4. Load is above capacity of jack.

6. Packing worn out or defective.

Jack lifts only

1. Too much or not enough oil.

partially

Jack advances

1. Pump not working correctly.

slowly

Jack lifts load, but

1. Cylinder packing is leaking.

doesn't hold

2. Valve not working correctly

(suction, delivery, release, or

bypass).

3. Air-locked system.

Jack leaks oil

1. Worn or damaged seals.

Jack will not

1. Release valve is closed.

retract

1- 1/2 TON TRANSMISSION JACK PART LIST

Solution

1. Close release valve.

2. Fill with Oil and bleed system.

3. Bleed system.

4. Use correct equipment

6. Install seal kit

1. Check Oil/eve!

1. Install seal kit, or replace power Unit.

1. Install seal kit

2. Inspect valves. Clean and repair seat

surfaces.

3. Bleed system.

1. Install seal kit.

1. Open or clean release valve.