Docucap DocketPORT 468 사용자 설명서 - 페이지 7

{카테고리_이름} Docucap DocketPORT 468에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Docucap DocketPORT 468 12 페이지.

Initial Calibration with DocketSCAN II

NOTE: Calibration is a critical step in setting up your scanner. It allows the image quality to

be "balanced" for your computer and scanner combination. If at any time you switch the

computer that you use with your scanner, or change scanners, you will be required to calibrate

again.

To launch the DocketSCAN

icon in your system tray or shortcut icon on your desktop or the "Taskbar tray" icon

(usually in the lower right-hand corner of the Windows desktop).

Once you have launched DocketSCAN II

button and the step-by-step calibration instructions will appear in a succession of prompts.

This calibration process will require the special black and white calibration sheet that was

included with your scanner. When calibrating make sure the page with the black bars are

facing down and note the direction of the arrows for proper insertion. When the

calibration process has been completed successfully, you will see the message above

otherwise you would need to re-calibrate again.

If you switch scanners or your image quality has become unsatisfactory, you can

re-calibrate your scanner by choosing the CUSTOM button in the DocketSCAN II

and select the Calibrate button.

Should you lose or forget the black and white calibration paper that was included with your

scanner, you can simply use any plain "white" (the brighter the "white" the better) piece of

letter size (or A4) printer paper to perform the calibration. Simply fold the paper in half

and insert the folded end into the scanner first when calibrating.

The following message will be displayed (see below).

II application you can either double-click the DocketSCAN II

for the first time, you should select the SCAN

- 6 -

.....................

window