DOD FX7 소유자 매뉴얼 - 페이지 12

{카테고리_이름} DOD FX7에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOD FX7 18 페이지. Dod guitar effects processor/preamp owner's manual fx7

Storing Programs

User

Store

DATA

User

Store

signal processing

NOTE: When you change the selected Parameter from the stored

value, a decimal point appears in the bottom right corner of the

display and the Store LED lights.

That's it! You can manipulate any effect setting in the FX7 by pressing

the associated Effect selector button on the front panel and turning

the Data wheel. The Effect Group buttons also toggle the effects on

and off with each successive press of the button.

When you're editing Programs, be sure to pay attention to the flashing

Status LEDs. This helps you keep track of where you are in the menus.

IMPORTANT: If you want to store your custom Program so you

can use it later, follow the procedure below.

The FX7 helps you remember whether or not you've stored the

Program you're working on by lighting the Store LED under the bot-

tom right corner of the display when the selected Program has been

edited.

Remember that if you change any settings in a Program, you have to

store the Program into a User memory location. Otherwise, all your

changes will be lost.

To store a Program into a memory location:

1) Press the Store button. The Store LED begins flashing and the

User LED lights (if not lit already).

2) Use the Data wheel to select the User location where you want

to store the Program.

3) Press the Store button again to store the Program in the loca-

tion you selected.

After the storing procedure is complete, the FX7 returns to normal

operation at the new Program location.

NOTE: Factory Programs can't be overwritten. When you modify

a factory Program and store it in memory, the Program is stored in

the corresponding number location in the User Program section.

The FX7's bypass functions are very simple.

To bypass individual effects:

1) From Program mode, decide which effect you want to bypass

and press its Select button twice. The display reads:

-- .

FX7 owner's manual