DOD 410 SERIES II 소유자 매뉴얼 - 페이지 6
{카테고리_이름} DOD 410 SERIES II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOD 410 SERIES II 13 페이지. P.a./monitor processor
R410 Manual
6/8/99
10:41 AM
6
INSTALLATION
Install the 410 in a rack with the provided rack screws. Route
the AC power cord to a convenient power outlet away from
audio lines.
Connections to the input and output jacks are made using 1/4"
balanced tip-ring-sleeve (TRS) plugs, or 1/4" unbalanced tip-
sleeve (TS) plugs, or balanced XLR plugs.
For balanced connection; wire the plug as follows:
High(+)
Low(-)
Ground
For unbalanced connection; wire the plug as follows:
High(+)
Ground
Once the 410 has been installed and adjusted, an optional 801
security panel may be installed to keep unauthorized persons
from tampering with the settings.
APPLICATIONS
A. Using the 410 in conjunction with a real time analyzer
(such as DOD's RTA Series II), a calibrated microphone, and
pink noise generator, the audio system may be tuned to make
the overall audio spectrum response of the sound system and
the room environment flatter in frequency response.
B. Greater gain-before-feedback characteristics may be
achieved by turning up the sound system to the feedback point
and attenuating the oscillating (ringing) frequency using the
notch filters. Turn the system up to feedback again and attenu-
Page 6
1/4"
XLR
Tip
Pin 2
Ring
Pin 3
Sleeve
Pin 1
1/4"
Tip
Sleeve