DOD R410 Series II 소유자 매뉴얼 - 페이지 6

{카테고리_이름} DOD R410 Series II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOD R410 Series II 13 페이지. P.a./monitor processor

R410 Manual

6/8/99

10:41 AM

INSTALLATION

Install the 410 in a rack with the provided rack screws. Route

the AC power cord to a convenient power outlet away from

audio lines.

Connections to the input and output jacks are made using 1/4"

balanced tip-ring-sleeve (TRS) plugs, or 1/4" unbalanced tip-

sleeve (TS) plugs, or balanced XLR plugs.

For balanced connection; wire the plug as follows:

High(+)

Low(-)

Ground

For unbalanced connection; wire the plug as follows:

High(+)

Ground

Once the 410 has been installed and adjusted, an optional 801

security panel may be installed to keep unauthorized persons

from tampering with the settings.

APPLICATIONS

A. Using the 410 in conjunction with a real time analyzer

(such as DOD's RTA Series II), a calibrated microphone, and

pink noise generator, the audio system may be tuned to make

the overall audio spectrum response of the sound system and

the room environment flatter in frequency response.

B. Greater gain-before-feedback characteristics may be

achieved by turning up the sound system to the feedback point

and attenuating the oscillating (ringing) frequency using the

notch filters. Turn the system up to feedback again and attenu-

Page 6

1/4"

XLR

Tip

Pin 2

Ring

Pin 3

Sleeve

Pin 1

1/4"

Tip

Sleeve