Flepcher FLP-EP9060 운영 매뉴얼 - 페이지 8

{카테고리_이름} Flepcher FLP-EP9060에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Flepcher FLP-EP9060 13 페이지. Alarming signal generator

페이지 인쇄

5. MACHINE OPERATION

MANUALLY OPERATION

1 .

When the machine stands in the state of working.

(1)Siren alarms : when you set the optional switch

at siren , press play knob , then it has a short siren

output;press alarm mode and select longalarming

mode,press play knob again,and it has a longsiren

output.

(2)Play recording to alarm: when you set the optional

switch at MSG, press play knob, it has a recording

sound output; press alarm mode and select longalarm

mode , press play knob again, then the recording will

be outputted repeatedly.

2 When the machine stands standby, you can't play

siren or recording manually.

AUTOMAITC MODE

1 Siren alarms : when you set the optional switch at

SIREN,if you input a trigger signal in the siren spigot

at the real panel, and the output spigot won't output

siren signals till the trigger signal is relieved

(1)Play recording alarm : set the optional switch at

MSG , if there is a trigger signal being inputted in

the siren spigot at the real panel , then the output

spigot OUTPUT will output recorded signals , you

can press STOP to cancel alarm according to the

alarm mode by your command.)

(2)Play recording to alarm: when you set the optional

switch at MSG, press play knob, it has a recording

sound output ; press alarm mode and select long-

alarm mode , press play knob again , then the re-

cording will be outputted repeatedly.

(3)When you haven't cancelled the input trigger signals

in the alarm spigot at the real panel,and place the

optional switch at SIREN or MSG, you can get corresp-

onding input

2 When the machine stands standby, the STOP knob

can't work, others are as above.

Recording operation:

Before recording , you need erase the whole

recording, and then record,the detailed steps

are as follows:

1 Place the optional switch at LINE or MIC.

2 Press START and STOP simultaneously and

keep it for more than 3 seconds till the PLAY/

RECORD indicator light is ON simultaneously.

3 PLAY indicator light is ON and RECORD light

is OFF,it express finished the erasure and the

CMOS chip is empty.

4 According to the record audio,place the option

switch at the LINE AND MIC (make the switch

and channel relatively), and press the START

to startup record.At this moment, PLAY light is

OFF, RECORD light is ON.

5 CMOS chip is recorded fully or press the STOP

key,the RECORD light is off.The chip can record

one minute at the most.

6 After finish the record, make the option switch

turn to PLAY MSG to play.