Clinispin Horizon 755VES 운영자 매뉴얼 - 페이지 9

{카테고리_이름} Clinispin Horizon 755VES에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clinispin Horizon 755VES 16 페이지. Laboratory centrifuge

페이지 인쇄

Twenty (20) Place Fixed-angle Rotor (optional):

This rotor is designed to hold up to twenty (20) tube holders.

It comes with three tube holder types. The orange holders are

designed to hold tubes up to 15mL (up to 17mm x 125mm). The

purple holders are designed to hold tubes up to 10mL

(up to 17mm x 100mm). The blue holders are designed to hold

tubes up to 5mL (up to 17mm x 75mm).

Your centrifuge must contain a balanced load in order to work properly. to ensure

that the load is balanced, keep these rules in mind when inserting test tube samples

into the 20 place fixed-angle rotor:

Opposing tube holders must be identical.

Opposing tube holders must be empty or loaded equally weighted samples.

If an odd number of samples is to be spun, use a water-filled tube to mate

with the unpaired one.

DiRectionS:

Compare the tube to be spun with the four boxes shown below.

2. Find the box that most closely matches the tube's length. nOTE: The tube length with

its stopper or cap must be shorter then the chosen box.

3. Match the letter from the chosen box with one of the configurations shown.

For Example: A tube is found to be as long as box B. Accordingly, we can

use a 125 mm tube holder with a 1525 cushion or a 100mm tube holder

with no cushion, (configurations B1 or B2).

ORANGE

125mm

Tube

Holder

C1.

PURPLE

100mm

Tube

Holder

with

1525

cushion

page 9

B1.

B2.

PURPLE

ORANGE

125mm

100mm

Tube

Holder

with

1525

cushion

C2.

BLUE

75mm

Tube

Holder

75mm Tube Holder

with

1525 cushion