Etac Next 사용자 설명서 - 페이지 12
{카테고리_이름} Etac Next에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Etac Next 12 페이지.
페이지 인쇄Rear wheels:
Tyre pressure:
Castors:
Chassis:
Upholstery:
(!) When necessary, lubricate moving parts/joints with cycle oil or similar.
The wheelchair is pulling
diagonally
The wheelchair is difficult to
manoeuvre
The wheelchair is difficult
to turn
The brakes are ineffective
The rear wheels are "loose"
The rear wheels are difficult
to fit/remove
The castors "wobble"
The wheelchair is difficult
to fold/unfold
The wheelchair feels
"unsteady"
7 320451 307491
Maintenance
Clean quick release axles as required.
Check tyre pressure, see tyre page (once a month).
Clean castor axles as required.
Clean the chassis with non-abrasive detergent, pH value 5-9 or
with 70 % disinfectant solution. Rinse and dry.
Wash - see label on upholstery.
In the event of problems, contact your Assistive Equipment
Centre.
Troubleshooting table
- Pump up the tyres
- The rear wheel mountings are incorrectly fitted
- The user's weight is not evenly distributed in the wheelchair
- The driving force is stronger on one side.
- Release the tilt handle so that the bars are parallel (Next Comfort)
- Pump up the tyres
- The rear wheel mountings are incorrectly fitted
- Remove any hair or dirt from the castor axles
- Too much weight over the castors; adjust the wheelchair's balance
position
- Pump up the tyres
- Check that the front forks can rotate
- Remove any hair or dirt from the castor axles
- Too much weight over the castors; adjust the wheelchair's balance
position
- Pump up the tyres
- Adjust the hub axle length
- Lubricate and clean the quick release with cycle oil or similar
- Adjust the hub axle length
- The front forks have not been tightened sufficiently
- Too much weight over the castors; adjust the wheelchair's balance
position
- The upholstery is too taut
- Lubricate and clean the cross elements under the seat
- Pump up the tyres
- Check that screws, handrims and brakes are properly tightened
74731