Clippasafe 130 사용 설명서 - 페이지 2

{카테고리_이름} Clippasafe 130에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clippasafe 130 5 페이지. Extendable swing shut gate

페이지 인쇄

Location

WARNING - INCORRECT FITTING

OR POSITIONING OF THIS SAFETY

BARRIER CAN BE DANGEROUS

Fixing surfaces must be suitable

for the purpose and structurally

sound.

This product requires the purchase

of appropriate fixing aids suitable

for the surface to which the wall

cups are to be fitted.

If this gate needs to be fitted to

a round shaped newel post,

'Y' shaped spindles are available

separately which replace the screw

adjusters and wall cups supplied

with this gate.

Bottom of

Stairs

Top of

Stairs

THIS GATE OFFERS THE

FOLLOWING FIXING

OPTIONS:

LOW PRESSURE MOUNTING

WITH SCREWED WALL CUPS

SUITABLE SURFACES

0 ^

O D-

O -i

§s

Pre-lnstallation Advice

WARNING - NEVER USE WITHOUT WALL CUPS

WARNING - GATE MUST BE FITTED UPRIGHT AS SHOWN

IN ORDER FOR THE SELF-CLOSING MECHANISM TO

FUNCTION CORRECTLY

WARNING - WHEN FITTING ON A STAIRWAY ALWAYS BLOCK

ONE OPENING DIRECTION SO THAT THE GATE WILL ONLY

OPEN AWAY FROM THE STAIRS (see Installation Instructions).

90°

Installation

Without extensions, this gate is suitable for openings between 72.5cm (281/2in) and

81cm (32in) wide. If gap is wider, see extension guide in section G. Fit extension(s) first,

then follow instructions below.

1. Insert the spindles (1) with nuts (2) into the holes in the four corners of the gate.

2. Mark the positions for the wall cups (4) on both wall surfaces.

The holes for the lower wall fixings should be 27 mm

above the floor.

The holes for the upper wall cups should be 747 mm

above the floor.

747mm

27mm

FLOOR

3. Fix the wall cups (4) using appropriate fixings depending on the surface. Wood screws

for wood surfaces, appropriate wall-plugs and screws for brick /concrete / plaster walls and

metal screws for metal surfaces. These screws and fixings are not supplied.

Use Size 6 (3.5mm

diameter) flat headed

counter sunk screws

of minimum length

25mm.

Place the gate into position, and locate the spindles into the wall cups. Keeping the gap

between the wall and the gate equal on each side, adjust the spindles and tighten the nuts

on each corner of the gate using the spanner (3).