DOEPEFER A-157-3 매뉴얼

{카테고리_이름} DOEPEFER A-157-3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPEFER A-157-3 4 페이지. Trigger-sequenzer

DOEPFER

1. Introduction

The Trigger-Output Module A-157-2 and the Control-

Input Module A-157-3 are both required to drive the

Trigger Sequenzer A-157-1:

The Trigger-Out Module A-157-2 is where the trigger

signals (+12V) for each sequencer track can be tapped

from.

The Control-Input Module A-157-3 is used to control the

sequencers run functions (start / stop / reset / clock). You

can either control them manually using the push buttons, or

by applying external signals of ≥ +3 Volts.

Please note: To run the sequencer, an external clock signal

has to be patched to the A-157-3 clock input socket. Please

refer to page 2.

IMPORTAND: Before installing the modules A-157-2

and

A-157-3

please

instructions on pages 3 and 4 !

System A-100

read

carefully

the

setup

Trigger-Sequenzer A-157-2/3

2. A-157-2 Trigger Output Module

The Trigger-Output Module A-157-2 is self explaining. The

eight sockets provide the trigger signals (+12V) for each

sequencer track.