DOEPFER A-100 Series 조립 및 배선 매뉴얼 - 페이지 5

{카테고리_이름} DOEPFER A-100 Series에 대한 조립 및 배선 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPFER A-100 Series 6 페이지. Analog modular system, connecting the breakout module to the main module
DOEPFER A-100 Series에 대해서도 마찬가지입니다: 사용 설명서 (8 페이지), 매뉴얼 (16 페이지), 사용자 설명서 (12 페이지), 매뉴얼 (8 페이지), 매뉴얼 (8 페이지), 매뉴얼 (6 페이지), 연결 (8 페이지)

페이지 인쇄
DOEPFER A-100 Series 조립 및 배선 매뉴얼
Die beiden verbleibenden Anschlüsse des Flachbandkabels
(Masse/GND und Signal) werden an die BNC-Buchse des
VPS10 angelötet. Die Masseleitung (GND, 3 miteinander
verlötete Drähte) werden an den Masseanschluss der BNC-
Buchse mit angelötet. Die Signalleitung (einzelner Draht)
wird an den Mittelanschlussder BNC-Buchse mit angelötet.
Darauf achten, dass beim Anlöten die vorhandenen
Verbindungen zwischen der BNC-Buchse und der VPS10-
Platine nicht unterbrochen werden, sondern die neuen
Anschlüsse nur mit angelötet werden:
BNC-Buchse
BNC socket
Die beiden folgenden Abbildungen zeigen den Aufbau aus
zwei verschiedenen Ansichten vor der Endmontage.
The two remaining terminals of the ribbon cable (GND and
signal) are soldered directly to the BNC socket of the
VPS10. The GND wires (3-fold) are soldered to the GND
terminal of the BNC socket. The signal wire (single wire) is
soldered to the center pin of the BNC socket. Pay attention
that the existing connections between the VPS10 pc board
and the BNC socket are not interrupted during the soldering
but that the wires are soldered in addition to the existing
connections:
The next two pictures show the assembly from two different
aspects just before the final mounting.
Signalanschluss
signal pin
Masse-Anschluss
GND pin