DOEPFER A-190-2 매뉴얼 - 페이지 12

{카테고리_이름} DOEPFER A-190-2에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPFER A-190-2 13 페이지.

Midi-to-CV/Gate A-190-2

6.2. Application of A-190-2 and Precision Adder A-185-2

In this application the A-185-2 is used to add up several voltages that are used to control the pitch of all VCOs that are

connected to the same bus board as the A-185-2:

•

CV Note is connected to one of the inputs of the A-185-2 without attenuator

•

CV Pitch Bend is connected to the input of the A-185-2 with attenuator to be able to adjust the pitch bend width

•

CV Ctr is connected to the control input of a VCA (e.g. A-130) and controls the level of the triangle signal of the LFO

A-145. The output of the VCA is connected to one of the inputs of the A-185-2 without attenuator. That way the Midi

controller (e.g. modulation = control change #1) is used for the modulation depth. If the A-145 is replaced by a

VCLFO A-147 the CV Volume of the A-190-2 may be used to control even the modulation frequency of the LFO.

•

The CV output of a sequencer A-155 can be connected to the remaining free input of the A-185-2. Then the CV

Note of the A-190-2 is used to transpose the sequence of the A-155 via Midi.

Attention:

In this application the bus CV jumper of the A-190-2 has to be removed and the bus CV jumper of the A-185-2

has to be installed ! Otherwise a short circuit between both CV outputs is made !

System A-100

DOEPFER