DOEPFER LMK2+ 사용자 설명서 - 페이지 2
{카테고리_이름} DOEPFER LMK2+에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DOEPFER LMK2+ 12 페이지. Midi master keyboard usb version
DOEPFER LMK2+에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (6 페이지)
페이지 인쇄
INDEX
1
2
Midi Connection
3
USB Connection
4
5
6
OPERATING AND SECURITY INSTRUCTIONS
7
7.1
7.2
7.3
APPENDIX A: Information about the velocity response curves
APPENDIX B: Pin assignement of the jack sockets
APPENDIX C: Velocity reduction factor for the black keys
APPENDIX D: Information about the 16 factory presets
Important Note: Initialization of the unit
To initialize the unit (i.e. to re-establish the factory settings) one has to operate the buttons 1,2,7 and 8
(PRESET + PRG/REAL T. + CONTR. + PANIC) simultaneously during power on. Then all LEDs light up eight
times. The unit has to be turned off and on again. The devices should remain about 10 seconds in the off state
before it's turned on again. After that the user preset has the same values as from the factory. The values are
the same as for the fixed factory preset #2, i.e. entire keyboard Midi channel 1, all controllers active, wheel 1 is
assigned to Midi-controller #1 (modulation). One may use the initialization if the user preset is totally mis-
adjusted. In this case it may be easier to initialize the whole unit than to readjust each single parameter. If the
keyboard for example does no longer output Midi note messages the split zone parameters lower/upper key are
probably misadjusted - e.g. lower = upper key, i.e. the zone is one single key only
LMK2+/USB User's Guide
LMK2+/USB User's Guide Page 2