Clipsal 560884 사용자 설명서 - 페이지 6
{카테고리_이름} Clipsal 560884에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Clipsal 560884 20 페이지. Multi room audio matrix switcher
페이지 인쇄Multi Room Audio Matrix Switcher
Figure 1 – Never plug a C-Bus cable into a digital audio socket or vice versa
3.0
Using the Matrix Switcher
This section describes how to use a Matrix Switcher which has been
installed as part of a Multi Room Audio system. Installation details are
provided in the Multi Room Audio System Installation Manual.
3.1
Powering the Unit
The Matrix Switcher must be plugged into an AC mains power outlet, via
the supplied IEC type cable. A switch is located next to the AC power
socket at the rear of the unit. Push the top of the switch inwards to turn
the Matrix Switcher on.
3.2
Front Panel Control
The front panel of the Matrix Switcher (shown in Figure 2) has eight
buttons which are used to view and control the status of each zone.
Power indicator
Figure 2 – Matrix Switcher front panel
6
Digital audio
Only use F 3,15A L 250V fuse
1
IR OUT
2
DIGITAL AUDIO OUT
CAUTION: USE ONLY WITH C-Bus MULTIROOM AUDIO SYSTEM AMPLIFIERS
ZONE 8
ZONE 7
ZONE 6
ZONE 5
ZONE 4
OPTICAL
OUT
IN
ZONES
1
2
3
SOURCE INPUT
1
2
3
DIGITAL
AUDIO
ZONE 3
ZONE 2
ZONE 1
IN
LCD
4
5
6
7
Zone selection buttons
C-Bus
BROADCAST
USB
C-Bus
4
L
Unit
R
8