Doepke DTS 2 사용 설명서 - 페이지 4

{카테고리_이름} Doepke DTS 2에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Doepke DTS 2 6 페이지. Temperature sensor board

Doepke

7. General Information

The DTS 2-P temperature sensor board is a component of the Dupline installation sys-

tem and allows the conversion of analog temperature values (-30°C up to +60°C) for

transmission on the Dupline bus.

The DTS 2-P transmits the temperature data on one free encodeable Dupline channel

and does not need an external power supply since it is supplied by the Dupline bus.

Due to its design it fits into conventional flush-mounted installation boxes.

• The installation may only be carried out by an authorised technician

• This device is suitable exclusively for operating through the signal conductors of the

Dupline bus system, which have been installed in accordance with the requirements

for protective low voltage (see VDE 0100, Part 410, or EN 50090-9-1). Other signal

voltages - even if extensive protective measures are taken - may lead to irreparable

damage to the device as well as danger to people. For further guidelines refer to the

Dupline Planning Aid.

• The DTS 2-P is an open, unprotected circuit board. When touching the DTS 2-P any

static charge of the body could damage the board's components. Therefore, before

mounting it discharge body static by touching earthed objects with your hands

With the DHK 1 hand encoder the analog data channel can be assigned any address be-

tween A1 and P8 via the modular plug connector. The allocation of the channel is as fol-

lows:

Channel

Temperature data

Functions which are not required should remain uncoded. Encoding the DTS 2-P re-

quires neither a power supply nor the Dupline signal. Although the coding is permanently

retained, it may always be overwritten.

Installation may only be carried out by an authorized technician. The DTS 2-P is suitable

for installation in flush-mounted housings; to achive a correct temperature measuring it

is necessary that air can pass through the housing unhindered. Observe the connection

diagram on page 6 when installing.

All leads to be connected must be dead. Connections between the Dupline signal and

earth potential will cause malfunctions and are not permissible. In addition, check for the

correct polarity of the Dupline signal. The following table illustrates the connection con-

3931232/2009.02/C - The right to make technical changes reserved!

Operating Instructions

DTS 2-P Temperature Sensor Board

Description

1- Table of Contents

Channel

Not assigned

2..8

Description