DOF Reality M2 설정 지침 - 페이지 13

{카테고리_이름} DOF Reality M2에 대한 설정 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DOF Reality M2 14 페이지.
DOF Reality M2에 대해서도 마찬가지입니다: 설정 지침 (15 페이지)

4) Open with notepad file SMC3Utils.ini and set COMM_PORT= to proper COM port number

from your Windows Device Manager or SimTools

5) start/run SMC3Utils.exe

6) select the problematic motor (left motor brown plug is Motor 1, right 2 black plug, rear Motor

3 white plug) most probably it is shown as OFF.

7) write down current Max Limits and Clip Input values (on the right of the SMC3Utils window)

and reduce them to 0

8) in SMC3Utils click small OFF button to the right of the motors selection, so it becomes ON.

9) power ON the platform

10) motor should move back to normal position, you can try 'Sine' for it to see that it moves fine

and measured motor position = green line goes along with desired motor position = blue line.

11) if all is good restore original Max Limits and Clip Input values (you need to increase Clip first

and then Max as max can't be bigger than Clip) and close SMC3Utils

5.3 Motor arm is not horizontal in neutral position

Over time motor-sensor coupler bolts may get loose and neutral motor position can get off from

normal (just a bit higher that horizontal). Proceed with this motor calibration

https://www.youtube.com/watch?v=Wa6hRdMB4vA

5.4 Something is wrong with my platform !

0) check all cables and motor connections, and any loose wires inside the control box.

1) close all SimTools applications

2) Download

http://dofreality.com/SMC3Utils.zip

3) unpack all archive contents into any local folder on your PC

4) Open with notepad file SMC3Utils.ini and set COMM_PORT= to proper COM port number

from your Windows Device Manager or SimTools

5) start/run SMC3Utils.exe

6) power ON the platform

7) Set it to 'sine' click Motor 1 and Motor 2 and 3 send us ([email protected]) screen shots of

SMC Util charts for each motor separately and SMC under chart settings you have and a short

video clearly showing the problem

5.5 I have troubles installing SimTools (Antivirus detects it as a thread)

SimTools uses a variety of methods to read the telemetry from the game and some of those

methods will trigger the antivirus. SimTools is completely safe and making an exception for

SimTools will solve the problem.

Setup Instructions DOF Reality M2