Cannondale Synapse Carbon 사용 설명서 부록

{카테고리_이름} Cannondale Synapse Carbon에 대한 사용 설명서 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Cannondale Synapse Carbon 2 페이지.
Cannondale Synapse Carbon에 대해서도 마찬가지입니다: 사용 설명서 부록 (20 페이지)

페이지 인쇄

Cutting the Seat Post

Depending on the frame size of your Synapse Carbon, the seat post

may require cutting to a shorter length. This must be performed by

a professional bike mechanic. The Synapse Carbon frame has seat

post depth in the seat tube that varies with the frame size.

frame sizes can accept between 110-130mm. Larger frame sizes can

accept between 110-150mm.

(Saddle not shown)

17 Nm

(Saddle not shown)

SEAT POST

8 Nm

17 Nm

SEAT BINDER

SEAT TUBE

SEAT POST

8 Nm

SEAT BINDER

SEAT TUBE

Figure 1.

To maximize saddle height adjustment range as well as maintain the

necessary minimum insert depth of 80mm of any seat post, the seat

post must be fitted (cut) to the frame.

To cut the seat post

1. Insert an uncut post into the seat tube. Insert it until it stops

inside the frame. It should slide in easily. Do not force it into the

seat tube. This is the maximum distance inside the seat tube the

post will insert.

2. Determine the maximum desired adjustment range of the

saddle that maintains the required 80mm of seat post inside the

seat tube. See Figure 1.

3. Remove the excess section from the end of the seat post. You

should use a cutting guide such as Park Tool SG-7 and a carbon

specific saw blade. See Figure 2. You should also lightly sand the

cut post to round and smooth the cut.

4. Re-mark the MINIMUM INSERT line 80mm up from the bottom of

the cut seat post. Mark the seat post without scoring, scratching

or otherwise damaging the surface of the seat post. Use a thin

decal (automotive pin striping) or a paint marker.

2009 Synapse Carbon

SEAT POST

Small

80mm

MINIMUM

INSERT

80mm

MINIMUM

INSERT

Figure 2.

NOTE: U.S. Consumer Product Safety Commission (CPSC) bicycle

regulations require minimum seat post insertion be marked on the

seat post.

If the seat post requires cutting, have it done by a professional

bike mechanic with experience cutting high-performance carbon

components.

YOU CAN BE SEVERELY INJURED, PARALYZED OR KILLED IF

YOUR IGNORE THIS WARNING.