1010 Music fxbox 빠른 시작 매뉴얼

{카테고리_이름} 1010 Music fxbox에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 1010 Music fxbox 2 페이지.

페이지 인쇄

Before You Start

A microSD card must be inserted into

fxbox before you can get started.

Fxbox takes audio input from IN1 and

IN2, processes the configured effects,

and sends the result to OUT1 and

OUT2. All settings are stored on the

microSD card.

Apply Effects

When fxbox starts up, the Touch Screen

Main

displays the

screen with the effects

grid. Activate an effect by doing one of the

following:

Touch a cell on the Touch Screen to

•

momentarily enable that effect.

Trigger the effect via CV signal by

•

plugging a gate signal into the CV

Trigger jack that maps to the effect

in the grid.

Set the effect to be always on by setting the

•

following the steps below. (Not all effects have a trigger property.)

Edit the Parameters of an Effect

Touch the cell of the effect in the grid on the

Push the Info button. You will see parameters specific to that effect, such as

Cutoff

Delay Time

and

Adjust a parameter by turning the Control Knob next to it.

4. Alternatively, touch and drag in the middle of the Touch Screen to control

the first two parameters using X/Y control. Move your finger left and right to

control the first parameter, up and down to control the second parameter.

Note:

The signal processing chain applies the effects in the same order in which you read a book: Left to right,

•

then top to bottom.

Select a Preset

Main

From the

–

touching the

and

02BadTapeEcho

(

Main

On the

screen, touch the preset name at the top of the grid (or the

space above it) to display the

Preset

Select a

Knobs, and then touching

Screen.

Note:

All changes you make to the sound are automatically remembered and

•

written to the preset. There is no option to "Discard Changes" or "Save Preset".

Mute Effects

Main

While on the

green.

Touch a cell to mute that effect. The cell will turn red. Touch it again to remove the mute.

Push the Home button to leave mute editing mode. A red bar appears over the names of muted effects.

3/9/17 3:20 PM

fxbox Quick Start Guide

screen, you can cycle through the list of presets by

buttons on either side of the preset name

Main

in the

Screen example shown above right).

Presets

by scrolling through the list with any of the Control

Load

in the top right corner of the Touch

screen, push the Home button to enter mute editing mode. The grid cells will be

Trigger Mode

property for the effect to

Main

screen.

Main

Screen

Presets

Screen