Dog trace d-control 1500 mini 사용자 설명서 - 페이지 6

{카테고리_이름} Dog trace d-control 1500 mini에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 1500 mini 19 페이지. Electronic training collar
Dog trace d-control 1500 mini에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)

페이지 인쇄

Battery insertion and replacement

INSERTION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER

Unscrew the 4 screws of the top of the receiver using a cross-head screwdriver and remove the lid.



Insert the lithium CR2 3V battery into the battery compartment. Please check that and the battery is

installed with correct polarity (according to the polarity indicated with the "+" symbol in the

battery compartment - see the picture). Wrong polarity may damage the unit.

A beep sound is emitted indicating the correct installation of the battery.



If the beep sound is not emitted after the battery is inserted, remove it immediately. Initialize the



system by using a metal tool (e.g. a screwdriver, scissors, etc.) and short-circuit (connect) both

contacts of the battery holder for about 2 seconds (see the picture on the page 16). Please check

the correct polarity and try to insert the battery again.

Before putting the lid of the receiver back in place, make sure that the rubber seal is correctly



seated in its groove. Screw down the 4 screws of the top tightly (do not over tighten them).

CHECKING THE BATTERY STATUS

LED indicator on the receiver's front cover indicates the status of the battery:

Green flashing LED indicates the battery is fully charged.



Red and green flashing LED together indicate low battery.



Prepare a spare lithium CR2 3V battery and follow the instructions

described in the section „Battery insertion and replacement".

Make sure that the receiver works correctly.

Battery polarity indicator