Dog trace d-control 1640 매뉴얼 - 페이지 7

{카테고리_이름} Dog trace d-control 1640에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 1640 18 페이지. Electronic vibration training collar
Dog trace d-control 1640에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

페이지 인쇄

Battery insertion and replacement

INSERTION (REPLACEMENT) OF THE BATTERY IN THE RECEIVER

Unscrew the 4 screws of the top of the receiver using a cross-head screwdriver and remove the lid.

Insert the lithium CR2 3V battery into the battery compartment. Please check that and the battery is

installed with correct polarity (according to the polarity indicated with the "+" symbol in the battery

compartment - see the picture). Wrong polarity may damage the unit.

A beep sound is emitted indicating the correct installation of the battery.

If the beep sound is not emitted after the battery is inserted, remove it immediately. Initialize the

system by using a metal tool (e.g. a screwdriver, scissors, etc.) and short-circuit (connect) both contacts

of the battery holder for about 2 seconds. Please check the correct polarity and try to insert the battery

again.

Before putting the lid of the receiver back in place, make sure that the rubber seal is correctly seated in

its groove. Screw down the 4 screws of the top tightly (do not over tighten them).

Checking the battery status

LED indicator on the receiver's front cover indicates the status of the

battery:

Green flashing LED indicates the battery is fully charged.

Red flashing LEDs indicate low battery. Prepare a spare lithium CR2

3V battery and follow the instructions described in the section

"Battery insertion and replacement". Make sure that the receiver

works correctly.

Battery polarity mark