Dog trace d-control 1640 사용 설명서 - 페이지 7

{카테고리_이름} Dog trace d-control 1640에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 1640 15 페이지. Electronic vibration training collar
Dog trace d-control 1640에 대해서도 마찬가지입니다: 매뉴얼 (18 페이지)

페이지 인쇄

– Medium charged battery

– Flat battery

If the battery is flat, insert new AA alkaline batteries into the battery compartment.

Make sure that the receiver works correctly.

TIP: The battery can be taken out easily by small screwdriver, which is placed

carefully under the the battery edge.

6.2 Switching the transmitter ON/OFF

Switching ON: Press down for 1 second the

display indicates that the unit is active.

Switching OFF: Again, press down for 1 second the

7.1 Battery insertion and replacement in the receiver

1. Screw out 4 screws from the battery cover using a cross-head screwdriver and

remove the lid.

2. Insert the lithium CR2 3V battery into the battery compartment with a correct

polarity (according to the polarity indicated with the "+" symbol in the battery

compartment – see the picture). A wrong

polarity may damage the unit.

When you insert the battery for the first time, or if

the battery is removed longer than a few tens of

minutes, you will hear an audible beep tone

indicating the correct installation of the battery.

Note: When you replace the battery quickly, you

may not hear the audible beep tone of the collar.

3. Make sure that the rubber seal is clean and

correctly seated in its groove. Clean any dirt

from the seal.

4. Put the battery cover of the receiver back and

screw in the 4 screws adequately.

7.2 Checking the battery status

The status of the battery is indicated by LED indicators on the side of the receiver.

(see chapter: 5 Product description – Receiver)

The batterry is fully charged – when switched on, green LED is flashing

The battery is low – when switched on, red LED is flashing

RECEIVER PREPARATION

button on the transmitter. The LCD

button on the transmitter.

Battery polarity mark