Dog trace d-control 200 mini 사용자 설명서 - 페이지 16

{카테고리_이름} Dog trace d-control 200 mini에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 200 mini 20 페이지. Electronic training collar – basic training set for one dog. electronic training collar – basic training set for two dogs – with a carrying case

페이지 인쇄

conditions, water can cause irreversible damage to your transmitter. The receiver is waterproof. The

receiver case is provided with a seal that forms a waterproof barrier between the lid and main housing

of the case. If the seal is loose, out of alignment or twisted, it will compromise the waterproof integrity

of the case. Lubricating the seal with a thin layer of silicone grease will increase its lifespan. We

recommend replacing the seal in the receiver every year. It is recommended to remove the battery

from the receiver, if the device will not be in use for a month or longer.

Troubleshooting

If your device seems to operate improperly, read this manual again, check the receiver battery and



replace it if necessary.

Try to initialize the receiver by removing the battery from the battery holder in the receiver, then



use a metal tool (e.g. a screwdriver, scissors, etc.) and short-circuit both contacts of battery holder

for approximately two seconds, and then put the battery back in its place observing the correct

polarity. A beep sound is emitted indicating the correct installation of the battery.

If the problem still persists, try to program the transmitter



with receiver again according to the instructions in this

manual.

If the problem still persists, contact the dealer.



While using the device, it is recommended to check periodically

TIP

that screws in the receiver lid are tightened correctly.

Short-circuit of the receiver