3M 7800 분해

{카테고리_이름} 3M 7800에 대한 분해을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 7800 4 페이지. Full facepiece
3M 7800에 대해서도 마찬가지입니다: 재조립 (4 페이지)

Let's begin with the facepiece.

To prepare the full facepiece for use with the GVP:

a. Remove the 701 Cartridge Inlets from either side of the facepiece.

b. Install a 7890 Plug into each inlet. The plugs should be replaced

when they are dirty or damaged.

c. Remove the 7890 Plug from the front DIN port.

To prepare the full facepiece for use with the Dual Airline:

a. Remove the 7890 Plugs, if it is not already fitted with a 701

Adapter. The 701 adapter allows you to attach the dual airline

breathing tube to the 7800 full facepiece.

b. Thread the assembled 701 adapters with the orange gaskets facing

outward into the cartridge connector port – do not tighten.

c. Install a 7890 Plug into the front DIN port.

The 7993 is the Welding Shroud, the 7915 is the Tyvek® Shroud.

The shrouds should be replaced when they are damaged, frayed or torn.

To remove the shroud:

a. Pull it up and over the facepiece, pulling the material from around

the DIN port and side ports when needed.

Tyvek is a registered trademark of E.I. DuPont Company.

The 7894 is the Standard Eyeglass Frame. Replace the frame when it

is damaged. To remove the it:

a. Lift the frame kit out of the inside of the facepiece.

b. An alternative frame is the 7925 Universal Frame Kit. It should be

replaced when it is damaged.

3M™ Full Facepiece 7800

Disassembly

7800 - Disassembly