Dog trace d-control 440 사용자 설명서 - 페이지 12
{카테고리_이름} Dog trace d-control 440에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 440 19 페이지. Electronic vibration training collar
Reprogramming of your receiver
The receiver can be programmed repeatedly without restraint using the same transmitter or another (see
the section Programming (pairing) of the transmitter and the receiver).
TIP: It is possible to program an unlimited number of receivers to a one transmitter.
Example: Button
3 in pairing regime and then press button for audible beep tone. All these receivers will perform the
same action at the same time when pressing function button. This can be used for two collars on the
neck of one dog, or for the training of higher number of dogs, where we give the same commands to
all of them at the same time.
Fitting the collar
The strap with the receiver (receiver collar) must be tightened enough so that the contact points are in
contact with the skin of the dog. We recommend you to fit the collar on the standing dog. When you can
fit two fingers between the collar and your dog's neck, the collar with the receiver are tightened enough.
If a dog has long or thick hair, it is suitable to trim the hair in the area of the contact points or to switch
to the longer contact points to ensure a consistent contact.
WARNING: If the collar is too loose, the receiver is likely to move and the repeating friction can
irritate the skin of your dog. Furthermore, in this case is not ensured a reliable contact of contact
points with the skin and a proper function of the training collar. We do not recommend to leave
the collar positioned at the same place for more than several hours, because it could irritate the
skin. If it is necessary to wear the collar for long periods, change regularly the position on the neck
of your dog. A collar with a receiver that is overly tight, can cause pressure sores on the skin in the
contact area of the contact points. If this happens, do not use the training collar until all traces of
irritation are gone.
12
is paired with 3 receivers, they can be programmed one by one or we can set all