Dog trace d-control 640 매뉴얼 - 페이지 12

{카테고리_이름} Dog trace d-control 640에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dog trace d-control 640 18 페이지. Electronic vibration training collar
Dog trace d-control 640에 대해서도 마찬가지입니다: 사용 설명서 (15 페이지)

페이지 인쇄

NOTICE: By modes 3 and 6 do not forget to switch off blinking by pressing the light button. Modes

4–7 can be used for differing dogs in darkness.

SETTING THE MODES:

Press a dog selection button 1 or 2 (depending on which button the required receiver is paired) until

symbol 1 or 2 starts blinking on the LCD. Set the required mode number (0–7) using the correction

impulse setting arrows. Confirm the selection by pressing button 1 or 2 again.

Control buttons

The buttons are used for quick setting of vibration and light modes which are displayed on the LCD in

numbers 0–4 (vibration modes) and 0–7 (light modes).

Control buttons

The buttons are used for dog selection. A different impulse level can be set for each dog.

It remains saved even after selection switching to the other dog.

Getting the best results

Training orders you send to your dog are transmitted from the transmitting unit to the collar equipped

with the receiver on radio waves. The propagation of radio waves is influenced by

a series of factors and under normal conditions the range of this unit is about 600-1600 meters (depending

on geographic conditions and surroundings).

If you want to get the best results with your unit, adhere to the following instructions:

To reach the best range for your communication, hold your remote controller in your hand and do not

cover its antenna.

If you hold your remote controller in front of you with your hand reached out, the range will get longer.

Before using your training set, always check the batteries in the remote controller and in the collar and

replace them if necessary.