Cygnus 850 E1 빠른 시작 설치 매뉴얼 - 페이지 3
{카테고리_이름} Cygnus 850 E1에 대한 빠른 시작 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cygnus 850 E1 6 페이지. 2 mbps modem
페이지 인쇄Menus flow chart of CYGNUS 850 E1 Modem
1.To view unit status
To view unit running
parameters
1.To configure system
2.To configure TDM
parameters
timeslots
1.To configure System
1.To configure all timeslots
Clocking mode
as IDLE
1. Line Slave 2. E1 Slave
2.To configure all timeslots
3. Internal
as E1
2.To configure Framing
3.To configure individual
Type
timeslots
1.To set to unframed 2Mbps
2.To set to framed nX64kbps
3.To configure Test Pattern
Type
1.To set to 2E11-1
2.To set to 2E15-1
4.To configure Rate vs Range
trade off
1.To set this to NO
2.To set this to YES
5.To specify unit ID
To configure unit ID
6.To specify console port
password
To configure Console
password
7.To store parameters in
NVRAM
To save the parameters
8.To reset the unit
To reset the unit
9.To configure factory
default parameters
To load the factory default
parameters
Root
2.To configure the unit
3.For control function
For diagnostics tests &
to view line Statistics
3.To configure DSL
4.To configure E1 port
port parameters
parameters
1.To configure E1 Port line
1.To configure DSL Type
1.DSL Type as LT
2.DSL Type as NT
2.To configure DSL Frame
2.To configure E1 Port
Type
1.Frame Type as Sync
2.Frame Type as Plesio
3.To configure PCM30
4.To configure PCM30
CAS ABCD idle signaling
Page 3 of 6
5.To configure Console
Port parameters
1.To configure Console
interface
Port speed
1.To set this to 75 Ohm
1.4800 bps
2.To set this to 120 Ohm
3.19200 bps 4.38400 bps
5.57600 bps
Framing Type
2.To configure Console
Port parity
1.PCM30 2.PCM30C
3.PCM31 4.PCM31C
1.Even 2.Odd 3.None
CAS ABCD signaling
3.To configure Console
Port Databits
1.To set this to 7 bit
2.To set this to 8 bit
4.To configure Console
Port Stopbits
1.To set this to 1 bit
2.To set this to 2 bit
Factory default parameters
System Clock : E1 Slave
DSL Type
: LT
Framing
: Unframed
2.9600 bps