3M 8210 사용자 지침 - 페이지 4

{카테고리_이름} 3M 8210에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. 3M 8210 8 페이지. N95 particulate respirator
3M 8210에 대해서도 마찬가지입니다: 기술 데이터 시트 (3 페이지), 사용자 지침 (18 페이지)

페이지 인쇄

3M™ Product Name

Wear It Right:

Putting on Your Respirator

1. Prepare to Use Respirator

• Wash your hands thoroughly with soap and water, or use

hand sanitizer, before handling.

• Inspect respirator for holes, tears or other damage to surface, straps, metal nose strip and nose foam. Get a new respirator if damaged.

• With model 8210, pre-stretch the straps before wearing.

• If you wear glasses, read steps 2 through 4, then remove glasses before putting on the respirator.

2. Place Respirator on Face

Place respirator against your face, with the bottom under chin and

metal nose strip across bridge of nose.

Pull the top elastic band over your head and position it high on the

back of your head.

Next pull the bottom elastic band over your head and place

around the neck below the ears.

3. Adjust the Metal Nose Strip

Use both hands to bend the metal nose strip to fit snugly against your nose and face. The respirator may not fit

as well if you pinch the metal nose strip using one hand. Use two hands. Slide fingers down both sides of metal

nose strip to seal it against your nose and face.

4. Check the Respirator-to-Face Seal

Remember: Putting the respirator on correctly means more of the air you breathe goes through the

respirator filter.

For non-valved respirators: Completely cover the outside of the respirator with both hands. Do not push the

respirator against your face. With your hands in place on the surface of the respirator, exhale, or breathe out

sharply. If you feel air blowing on your face or eyes, the respirator needs to be adjusted. To adjust, repeat

steps 2, 3 and 4. When respirator is a good fit, you will not feel any air blowing on your face or eyes. If you can't

get a good fit, try a different model respirator. Return glasses to face, if applicable.

For valved respirators: Completely cover the outside of the respirator with both hands. Do not push the

respirator against your face. With your hands in place on the surface of the respirator, inhale, or breathe in

sharply. If you feel air blowing on your face or eyes, the respirator needs to be adjusted. To adjust, repeat

steps 2, 3 and 4. When respirator is a good fit, you will not feel any air blowing on your face or eyes. If you

can't get a good fit, try a different model respirator. Return glasses to face, if applicable.

WARNING

Filtering facepiece particulate respirators are intended to help reduce breathing in airborne particles such as dust. If you do not

follow all instructions and limitations on the use of this respirator and/or do not wear this respirator during all times of exposure to

the particles, the respirator may not be as effective. The respirator cannot stop the breathing in of all particles in the air and does

not eliminate the risk of symptoms or sickness. For proper use of this respirator, see the User Instructions inside the package or call

3M at 1-800-247-3941.

Personal Safety Division

3M Center, Building 235-2W-70

S t . P a u l, M N 55144-1000

1-800-243-4630

Technical Service:

Customer Service:

1-800-328-1667

3M is a trademark of of 3M Company and affiliates.