Dogtra 2300NCP EXPANDABLE 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Dogtra 2300NCP EXPANDABLE에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogtra 2300NCP EXPANDABLE 15 페이지. Expandable up to 2-dog system additional receiver

페이지 인쇄

10. Using the Test Light

1. To turn on the receiver, place the red dot on the back

of the transmitter to the red dot on the receiver. Hold

the two red dots together for a moment until the LED

light on the receiver comes on. The indicator light will

come on for a moment then blink once every 4 seconds,

showing that the receiver is ready to use (the receiver

needs to be charged if the indicator light is red).

2. Turn the transmitter on by holding down the on/off

button on the right side of the transmitter. The LED will

blink every 4 seconds and the LCD screen will show

the remaining battery life (the transmitter needs to be

charged if there is only 1 bar showing on the battery

icon for the LCD transmitter screen).

3. Place the test light, included in the package contents,

on the contact points as shown in the diagram.

4. Watch the test light as you press the Nick button on the

transmitter. It should light up for just a moment. The

higher the intensity, the brighter the test light will be.

5. Watch the test light as you press the Constant button

on the transmitter. It should light up as long as the

button is pressed. However, as a safety feature, the

receiver will automatically stop the stimulation if the

Constant button is pressed for 12 seconds or longer.

6. Turn the Rheostat Dial on the transmitter clockwise

and then counterclockwise. The test light should glow

brighter with higher levels of stimulation and dimmer

with lower levels.

Note: The test light may not be visible if the intensity

level is set below level ten.