Dogtra 2700T&B 소유자 매뉴얼 - 페이지 8

{카테고리_이름} Dogtra 2700T&B에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogtra 2700T&B 19 페이지. 1-dog system only training & beeper collar

페이지 인쇄

3. Beeper Sound

When you press the Mode button the first time, the collar

will beep twice. The beeper unit will always start in Run/

Point mode. The beeper will sound every 7 seconds while

the dog is running, and every 2 seconds when the dog

is on point or becomes stationary. The second time you

push the Mode button, it will beep once and remain silent

while the dog is running and beep every 2 seconds when

the dog is on point or stationary.

To turn the beeper unit off, press the Mode button a third

time. The unit will emit three rapid beeps, and the beeper

will turn off. The Locate mode can still be used!

When the 2700T&B toggle switch is set on low pitch, the

beeper will emit a double beep when it is in Run/Point

mode or Point-Only mode. If the toggle switch is set on

the high pitch, a single beep will sound when using Run/

Point or Point-Only mode.

Initial Beeper

Mode

Sound

Press

Run/Point

2 Beeps

1st Time

Mode

Press

Point-Only

1 Beep

2nd Time

Mode

Press

No Beeper

3 Beeps

3rd Time

Mode

Note: The Locate button can be used in any mode you

are in.

Action

- Dog running/moving: emits

double beep every 7 seconds

- Dog stationary/pointing: emits

double beep every 2 seconds

- Dog running/moving: silent

- Dog stationary/pointing: emits

double beep every 2 seconds

No sound

4. Beeper Volume Adjustment

The beeper volume level for the Run/Point mode and

Point-Only mode can be increased or decreased by

holding the Locate button down and briefly pushing

the Pager button. The pitch of the beeper can be

selected with a toggle switch located on the face of the

transmitter. There are two beeper pitches: High (H1 =

lowest volume, H2 = medium volume, and H3 = highest

volume) and Low (L1 = lowest volume, L2 = medium

volume, and L3 = highest volume).

Toggle Switch

High LCD Displays

Press Pager 1st Time

(While holding down

the Locate button)

Press Pager 2nd Time

(While holding down

the Locate button)

Press Pager 3rd Time

(While holding down

the Locate button)

Note: The Locate beeper volume is not adjustable; it is

always on the highest level, L3 on low pitch, or H3 on high

pitch.

Toggle Switch

Low LCD Displays