Dogtra BALL TRAINER PRO 소유자 매뉴얼 - 페이지 9

{카테고리_이름} Dogtra BALL TRAINER PRO에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogtra BALL TRAINER PRO 12 페이지. Versatile dual-function launcher/dropper

페이지 인쇄

10. Replacing the Transmitter Battery

11. Using the Battery Correctly

1) When inserting the batteries into the transmitter, make sure the battery

matches the positive or negative polarity.

2) Please remove the batteries from the transmitter and fully charge the

receiver battery if it will not be used or placed in storage for a long time.

3) If you are storing the batteries, do not store it together with metal products.

4) If the battery expires, replace the battery with a new one even if it has some

capacity left.

1. Using a screwdriver, remove the

3 screws on the battery cover on the

back of the transmitter.

2. Replace the batteries with two AAA

1.5V alkaline batteries. Check that

the batteries match the polarity

indicated on the battery holder.

3. Place the battery cover back into

place and use a screwdriver to

tighten the screws back on.

Caution!

If you tighten the screws too much,

it will strip the screws and spin.

4. To make sure that the transmitter is

working properly, press one of the

buttons to see if the LED indicator

light shows up green.

12. Maximizing the Distance

Maximum range

Typical range

The range for the BALL TRAINER PRO is 100 yards, which can vary depending

on the way you use your transmitter. It may also vary depending on

geographical conditions and the surrounding environment.

To get the greatest range, follow the instructions below.

- To improve the range, hold the transmitter in your hand and do not block the

top of the transmitter (there is an internal antenna).

- Get the best range when holding the transmitter away from your body and

placing it above your head.

- Always check the batteries in your transmitter and receiver before usage.

Replace and recharge the batteries if necessary.

- The battery performance will decline when used in colder temperatures

(below 32°F).

13. Attaching the Belt Clip

Follow the instructions below to attach the included belt clip to the transmitter.

1. Align the belt clip to the grooves on the back of the transmitter.

2. With a firm grip, screw on the belt clip's Phillips head screws with

a screwdriver.

Caution!

Tighten until firmly in place. Be careful not to over tighten.

Minimum range