Dogtra T&B DUAL 코드 설정 매뉴얼 - 페이지 3
{카테고리_이름} Dogtra T&B DUAL에 대한 코드 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Dogtra T&B DUAL 4 페이지.
페이지 인쇄
2-DOG SET UP
Press the middle button to set the transmitter as a 2-dog system.
2
Select
1
Front side:
controls Dog 1
Left side:
controls Dog 2
2
1
The screen will show that both 'Dog 1' and
'Dog 2' have been set up.
If you want to change the side, please start over
by putting the transmitter in "Setting Mode."
or
1
Select
2
Left side:
controls Dog 1
Front side:
controls Dog 2
1
RECEIVER CODE SETTING
1.
2.
3.
2
2
4.
Attention! Do not code both receivers to the same side.
For any assistance, please email [email protected] or
call (888)-811-9111.
Turn the transmitter on (or leave on
after code setting the transmitter).
Set the Rheostat Dial to 0.
Turn on
With the receiver turned off, place
the red dot on the transmitter to the
red dot on the receiver. Hold the two
red dots together until the green
LED blinks rapidly on the receiver.
When the receiver light blinks rapidly,
separate the two devices.
On the transmitter, simultaneously press
or
1
the top two buttons of Dog 1's side you
selected.
For the second receiver, repeat and
press the top two buttons of the
opposite side of which you coded Dog 1.
When pairing is complete, the LED light
on the receiver flashes every 4 seconds.