Aseptico ADC-01P-RED AseptiChair 운영 및 유지보수 매뉴얼 - 페이지 5
{카테고리_이름} Aseptico ADC-01P-RED AseptiChair에 대한 운영 및 유지보수 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aseptico ADC-01P-RED AseptiChair 12 페이지.
페이지 인쇄
CHAIR ADJUSTMENTS:
1. Seat Height- The ADC-01P RED chair seat height can be set at
any of the five preset settings. Without a patient in the chair,
put your toe on one of the front chair legs and lift up slightly
on the chair seat. While lifting and holding seat, remove the
leg adjustment pin from the right and left side. Align link with
tube hole in any of the five positions and lock in place by
inserting the pin and chain assembly. (see Fig. 1)
2. Backrest- The backrest may be set in any
position from upright to full supine. To
change the position of the backrest, simply lift
the chrome friction lever on the back side of
the backrest, lower backrest, then release
lever to lock.
W RNING
NEVER LOWER THE BACK-
REST WHEN A PATIENT IS IN
THE CHAIR WITHOUT COM-
PLETELY SUPPORTING
THEIR WEIGHT FIRST.
To return the backrest to an upright position,
lift backrest to desired position. Backrest will
automatically lock in place. (Fig. 5)
3. Footrest- The footrest may be positioned
in the normal horizontal operating posi-
tion, or allowed to hang down vertically so
a patient can be seated in a sitting position.
To release footrest into the vertical posi-
tion, first fold toe section inward, then lift
slightly on footrest section. While lifting,
pull the black knobs on each side of the
chair frame to release and push footrest
down into the vertical position. Lock in
the vertical position by snapping holding
strap around the chair leg frame.
To reposition footrest in the horizontal
position, unsnap holding strap from frame,
lift footrest to the horizontal position until
it locks, then unfold toe section out to hor-
izontal. (Fig. 6)
4. Headrest- The headrest slides freely on its mounting strap and
can be positioned at different heights for different size patients.
Lift lever to position.
Release to lock.
Figure 5 - Backrest adjustment
Figure 6 - Positioning footrest to vertical
Pull Black
Knob to
Release
Snap
Around
Frame
Page 5