Cylon UCKRA420 설치 지침 - 페이지 2
{카테고리_이름} Cylon UCKRA420에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Cylon UCKRA420 4 페이지. Serial text keypad
페이지 인쇄The UCKRA420 may be mounted
a) in a Panel Door (see
b) on a Panel Backplate (see
or c) on a Pattress Box (see
Note: mounting options are available for US, UK and European Pattress Boxes.
In all cases, the mounting bracket is removed from the UCKRA420, and cable attached by either RJ-11 or Screw-
Terminal connectors as detailed below.
Section 1 - Removing the Mounting Bracket
Bracket locking
screw
Loosen the Bracket locking screw at the bottom of the
UCKRA420. (It is not necessary to fully remove the screw)
Section 2 - Connecting the UCKRA420 to UCxxPG-R controller
(not used)
GND
T/X
R/X
Power
(not used)
1. RJ-11 connector
Connect a cable to the UCKRA420 using an RJ11 plug OR a Screw-Terminal connector.
1. Downward cable channel
Route the cable through one of the cable channels so that the mounting bracket
can be re-attached.
UCDS-0035 rev 3.00
Unitron
UCKRA420 Installation Instructions
)
Section 6
)
Section 5
)
Sections 3 and 4
OR
2. Upward cable channel
Cylon Controls Limited
Accessories
Lift the bottom of the bracket away
from the UCKRA420, until it is clear
of the locking screw.
Power
R/X
T/X
GND
2. Screw-terminal connector
Connect the other end of the cable to the RJ-11 port
of a UC controller
UCKRA420
Unclip the top of the bracket by
pulling the bracket downwards
2