cymatic audio LR-16 제품 설명서 - 페이지 17

{카테고리_이름} cymatic audio LR-16에 대한 제품 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. cymatic audio LR-16 20 페이지. Line recorder 16 track digital direct-to-usb recorder 16x2 usb audio interface
cymatic audio LR-16에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 빠른 시작 매뉴얼 (8 페이지)

페이지 인쇄

12.2.7. Minimizing the Mixer Panel

The LR-16 Mixer Panel also be run in a minimized mode, which allows you to keep an eye on the

level meters, while the control panel itself uses much less space on your desktop.

12.3. Using the LR-16 as an Audio Interface with an OS X

12.3.1. Minimum System Requirements

Operating Systems:

•

Mac OS-X® 10.8 or higher

Hardware:

•

Any Mac hardware compatible with OS X 10.8 or higher

•

512 MB Ram (1GB or more recommended)

•

1 free USB 2.0 compatible port

NOTE: The speed of your processor, amount of RAM, and capacity, size, and speed of your hard

drives will greatly affect the overall performance of your recording system.

A faster processor and more RAM can reduce signal latency (delay) and improve overall

performance.

PRODUCT MANUAL

16X2 CHANNEL USB INTERFACE MODE

12.3.2. Driver Installation

There is no driver installation for Mac Computers necessary. Simply connect the LR-16 to your

Mac® by connecting the supplied USB cable to the LR-16 USB2.0 connector on the rear panel,

and an available USB2.0 port on your Mac.

The device will now be selecteable in the "Audio MIDI Setup" application, which can be found in

the Applications/Utilities folder.

Note that no custom LR-16 mixer control panel is available for the Mac, as there is when using the

LR-16 with Windows. The internal mixer of the LR-16 is not available when connected to a Mac,

so all monitoring must be done through the DAW software.

12.4. Using the LR-16 as an Audio Interface with an Apple® iPad®

12.4.1. Minimum System requirements

Operating Systems:

•

iOS® 5 or higher

Hardware:

•

iPad® 2 or newer

•

Apple® iPad Camera Connection Kit)

•

Apple Lightning to USB Camera Adapter

12.4.2. Driver Installation

There is no driver installation for the iPad® necessary. Simply connect the LR-16 to your iPad®

by connecting the supplied USB cable to the LR-16 USB2.0 connector on the rear panel and the

iPad® using the appropriate Apple USB adapter.

The LR-16 can now be used as a 16-inout, 2-output audio interface with the iPad® and appropriate

multi-channel iOS recording software.

16X2 CHANNEL USB INTERFACE MODE

PRODUCT MANUAL