DogWatch MB-1 제품 특징 및 사용 설명서 - 페이지 2
{카테고리_이름} DogWatch MB-1에 대한 제품 특징 및 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. DogWatch MB-1 4 페이지. Battery operated indoor/outdoor mobile boundary hidden fence transmitter designed to create small pet-free areas
페이지 인쇄
Top
Status Light
Power On/Off
Charging Port
Power on/off
• Turning Power on
The status light turns
green and blinks
several times.
• Turning Power off
The status light turns
red and then fades
out.
Bottom
Signal Range
Frequency
Rate Setting
Signal Range - Signal range is the distance the signal radiates from the center of the transmitter.
• Turn the knob toward 'max' to increase the size of the signal field.
• Turn the knob toward 'min' to decrease the size of the signal field.
Never adjust the signal range while your pet is wearing the receiver collar. Always test the signal
field and mark the edge of the field with flags before allowing your pet near the boundary area.
Frequency - Controls the broadcast frequency of the signal. Do NOT change this setting.
Features and Functions
The MB-1 may be used indoors or outdoors. The MB-1 is water resistant but
is not intended to be submerged in water/liquid. When used outdoors:
• The flap covering the charging port and the cover over the control
panel on the bottom must both be tightly closed. Both are rubber seals
which, when tightly closed, will help prevent water damage.
• The unit must be operated via battery.
• Do not place in direct sunlight.
Rechargeable Battery - Charge for at least 3 hours before using the first time.
The transmitter must be charged indoors. do not plug it in outdoors!
To charge the battery, plug the power adapter into an electrical outlet and
insert the other end securely into the charging port on the transmitter.
• The MB-1 should be charged only by the DogWatch power adapter.
• Do not leave the transmitter uncharged for long periods.
• Do not leave the MB-1 plugged-in when in use, except when charging.
• Do not charge if the transmitter temperature is below 32
The transmitter charges in approximately 3 hours when 'off' (charging takes
longer if it is turned 'on'). A protection circuit prevents overcharging.
Status Light - The status light lets you know: (a) if the transmitter is turned
'on'; and (b) the status of the transmitter battery.
STATUS LIGHT GUIDE
Battery Operated
Battery Charged
Battery Low
Plugged-In
Battery Charged
Battery Charging*
* When turned 'on', the transmitter is sending a signal, even while charging.
Transmitter 'On'
Boundary Activated
Light blinks green
every 15 seconds
Light double blinks red
every 15 seconds
Steady green light
blinks 'off' every 15 seconds
Steady red light
blinks 'off' every 15 seconds
2
o
f or above 110
Transmitter 'Off'
No Boundary Signal
Light Off
Light Off
Light Off
Steady red light
o
f.