DogWatch Scoot 운영 지침 - 페이지 2

{카테고리_이름} DogWatch Scoot에 대한 운영 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. DogWatch Scoot 4 페이지. Hidden fence systems
DogWatch Scoot에 대해서도 마찬가지입니다: 제품 및 기능 (10 페이지)

페이지 인쇄

Features

Scoot

is designed for small indoor

applications and allows you to

protect almost any area of your

house. Applications include

protecting your furniture, drapes,

carpets, window sills, countertops,

stairways, beds, cribs, etc.

Power Simply plug the power

supply into the transmitter jack.

Indicator Light A green light lets

you know that both the transmitter

and boundary wire are functioning

properly. A red light lets you know

that your boundary wire is not

connected properly or has a break.

Range The transmitter emits a

coded radio signal through up to 25 feet of boundary wire. You can

adjust the distance the signal radiates off the boundary wire by

using the left switch on the back of Scoot. When the switch is set to

the "HIGH" position, the range will be approximately two feet off the

wire. When the switch is set to the "LOW" position, the range will be

approximately one foot off the wire. Always test the signal field

before allowing your pet near the avoidance area. Never adjust the

transmitter while your pet is wearing the receiver collar.

Note: On the back of Scoot there are two small switches. The right

switch sets your transmitter to the correct broadcast frequency.

Your dealer will set this right switch for your system.

Do NOT change these settings. They are for DEALER USE ONLY.

Terminal Connections Strip and connect one end of the boundary

wire to one of the terminal connections. This is the beginning of

your boundary wire system. Once you have completed your

boundary, strip and connect the other end of your boundary wire to

the other terminal. The boundary wire must make a complete loop.

If the green power light turns to red it means that your boundary

wire is not connected properly or that there is a break in the wire.

Adjusting the Collar

Collar tightness is critical. All contact points must touch your dog's

skin in order to receive a correction. A loose collar will also allow the

contact posts to rub back and forth on the skin, possibly causing

irritation. Use care as over-tightening the contact posts could cause

damage to the receiver.

We recommend that the receiver collar be removed each day to

allow your dog's skin to gradually condition itself to the contact

posts and avoid potential skin irritation and possible infections.

Installation

To create a signal field using the boundary wire, you need to

separate the two strips of wire. The range of the signal will depend

upon the distance the two strips of wire are from one another. When

the two strips are next to one another, there is no signal field. As the

two strips are separated, the signal field will increase (see igure 1).

The boundary wire must form a continuous loop for there to be a

signal field. To accomplish this, you must splice the final ends of the

boundary wire together.

The boundary wire carries a harmless radio signal. You do not need

to worry about an electrical shock when separating and splicing the

boundary wire. The power indicator light will be "red" if you have not

closed the boundary loop or if you have a broken boundary wire.

igure 1

Smaller Signal Field

Larger Signal Field

Splice The Ends Together